For right-handed bowlers, the 7 pin is usually easier than the 10 — your hook is moving toward it rather than away from it. But it still gets missed, mostly in two ways: the ball dives into the left channel before it gets there, or, on leaves like the 4-7, the ball clips the front pin and leaves the 7 standing. There are two reliable ways to shoot it, and the right one depends on your ball, your release and the lane.
Where the 7 pin sits and why it gets missed
The 7 is the back-left corner pin, only a few boards from the left channel. Like the 10 pin for right-handers, it’s a target with the channel right next to it.
For right-handers, the main risk is too much hook. The ball is already curving left, and on many house conditions the outside boards are drier than the middle, so a hooking ball can grab those boards and finish into the channel. For left-handers, the 7 is the corner pin their hook moves away from, which makes it the equivalent of a right-hander’s 10 — covered at the end.
Option 1: Hook it with the 3-6-9 system
The classic approach uses the 3-6-9 system. Start from your strike position and target, then move your feet 9 boards to the right while keeping the same target. The extra angle sends your normal hook farther left on the pin deck, to the 7 pin.
This works well when:
- The lanes are fairly predictable, as on many typical league conditions.
- Your hook is moderate and consistent.
- You prefer to use one ball for everything.
Coaches have noted that on these easier house conditions, a right-hander can often shoot the 7 either straight or by letting the ball hook off the drier outside boards, and both can be high-percentage options. On flatter or longer oil patterns, though, the outside may not give a predictable hook, and a straight approach is safer.
For the full chart of 3-6-9 moves, see our guide to spare alignment and the 3-6-9 system.
Option 2: Shoot it straight with a plastic ball
The second approach uses a polyester spare ball and a straighter release on a cross-lane line:
- Move to the right side of the approach. How far depends on where the ball leaves your hand, which for most right-handers is several boards to the right of the slide foot.
- Pick a target around the third arrow (board 15) and adjust from there based on results.
- Angle your shoulders and hips toward that target and walk along the line, drifting slightly left.
- Keep your hand behind the ball with your thumb toward the pins, and finish with your palm up.
- Keep your eyes on the target until the ball passes it.
A plastic ball takes most of the guesswork out of the outside boards. If the lanes are drying out or you throw a lot of revs, this is usually the more consistent option. Our guide to spare bowling balls explains why polyester goes straight and how to choose one.
Which option should you use?
| Situation | Better choice |
|---|---|
| Mild, predictable hook on a typical house shot | Either; 3-6-9 with your strike ball is fine |
| Strong hook or lots of revs | Straight with plastic |
| Outside boards are dry and your ball is grabbing | Straight with plastic |
| Long or flat oil pattern | Straight with plastic, or a straighter angle with your strike ball |
| You keep missing left with a hook | Switch to plastic, or move feet left a board or two |
Many bowlers learn both and use whichever fits the conditions that day.
How to stop missing left
Missing left of the 7 usually means the ball is hooking too much or too early. Try these, one at a time:
- Reduce hook: switch to plastic, or flatten your hand position and limit wrist rotation.
- Move your feet left a board or two (with the same target). That brings the ball’s finishing point back toward the right.
- Add a little speed so the ball has less time to react on the dry boards.
- Check your target. If you’re looking past the arrows at the pin, it’s easy to pull the ball left.
- Check your follow-through. A swing that finishes across your body tends to send the ball left.
If the ball is missing right of the 7 instead, you need more angle: move your feet farther right, or let a little more hook in.
How to avoid chopping on 4-7 and other 7-pin leaves
“Chopping” means knocking down the front pin of a spare while a pin next to or behind it stays standing. On the 7 pin, it usually happens with a 4-7 leave: the ball hits the 4, the 4 goes down, and the 7 is left.
The 4 sits in front of and to the right of the 7. The most reliable way to convert is for the ball itself to hit both pins rather than relying on the 4 to deflect into the 7. To do that:
- Shoot the 4-7 from your 7-pin line (or very close to it), rather than your 4-pin line.
- Aim for the ball to hit the 4 full or slightly on its left side, so it carries on through to the 7.
- Avoid thin hits on the right side of the 4. That’s the typical chop: the ball deflects away to the right and the 4 may not be sent toward the 7.
The same idea applies to other leaves that include the 7. Find the key pin, then pick the line that lets the ball carry through to the 7 rather than relying on pin deflection. Our guide to pin leave names covers related combinations such as the 4-7 “fast eight” leave.
Troubleshooting table
| What happens | Likely cause | Try this |
|---|---|---|
| Ball hooks into the left channel | Too much hook or dry outside boards | Use plastic, flatten your hand, or move feet left a board or two |
| Ball misses right of the 7 | Not enough angle | Move feet farther right, keep the same target |
| 4 falls, 7 stays (chop) | Thin hit on the right side of the 4 | Use your 7-pin line and aim to hit the 4 full or on its left side |
| Misses in both directions | Inconsistent setup or eyes leaving the target | Fix one stance and target; keep eyes on the arrow |
Left-handers: shooting your corner pin
For left-handers, the 7 pin is the toughest corner pin — the mirror image of a right-hander’s 10. The same principles apply:
- Use a plastic ball if you have one.
- Move to the right side of the approach.
- Target the center arrow or the third arrow counting from the left channel.
- Angle your body to the target and walk along the line.
- Keep your hand behind the ball and finish palm up.
Our guide on how to pick up the 10 pin walks through this setup in detail; just reverse left and right.
Practicing the 7 pin
You can practice your 7-pin line on a full rack: set up exactly as you would for the 7 and throw. If the line is right, the ball will clip the 7 as it passes. Alternate this with your 10-pin line to practice switching sides of the lane. Our spare drills lay out these routines step by step.