Lanes and Machines

How to Read a Bowling Lane Oil Pattern Graph

How to read a bowling oil pattern sheet: length, volume and ratio, the graph and load table, forward vs reverse oil, the Rule of 31, and turning it into a game plan.

On this page
  1. What an oil pattern sheet is
  2. The three numbers that matter most
  3. Reading the graph itself
  4. Forward oil, reverse oil and the load table
  5. The Rule of 31: finding a breakpoint
  6. Turning the sheet into a game plan
  7. Checking it against the lane
  8. Worked example

What an oil pattern sheet is

An oil pattern sheet describes how a lane machine applies oil to a lane. Tournaments, sport leagues and pro events usually publish their pattern sheets, and many centers will show you their house pattern if you ask. Sheet layouts vary by lane machine maker, but most include:

  • A name for the pattern
  • Headline numbers: length, volume and ratio
  • A graph showing how much oil sits on each board at different distances
  • A load table listing how the machine was programmed

The three numbers that matter most

Length

Pattern length is how far down the lane, in feet from the foul line, the oil goes. It’s the single most useful number on the sheet.

  • Short patterns, very roughly under about 37 feet, let the ball reach dry lane sooner and hook earlier. They often favor playing straighter or closer to the outside.
  • Medium patterns, around 38 to 42 feet, are where most house shots sit.
  • Long patterns, around 43 feet and up, keep the ball skidding longer. They often push bowlers deeper inside or call for stronger equipment.

These bands are rough conventions, not official categories.

Volume

Total volume is the total amount of oil applied, usually shown in milliliters (mL). Many patterns fall somewhere in the 20s of milliliters. More oil generally means the ball has to work harder to grip, so stronger, more aggressive equipment tends to do better. Less oil favors weaker or more polished balls.

Volume and length together tell you a lot: a long, heavy pattern plays very differently from a short, light one.

Ratio

The ratio compares the oil in the center of the lane with the oil on the outside boards. A 3:1 ratio means about three times as much oil in the middle as on the outside, measured at specific boards.

  • High ratios, like many house shots at around 7:1 or more, create a crown of center oil that guides missed shots back to the pocket.
  • Low ratios, 3:1 or under, which USBC requires for sport patterns, give a flatter pattern with much less margin for error.

Reading the graph itself

Most pattern sheets show a color-coded chart. The exact layout depends on the software, but typically:

  • One axis is the boards, 1 to 39 across the lane’s width, often with board 20 marked as the middle.
  • The other axis is distance, in feet from the foul line to the end of the pattern.
  • Colors or bar heights show oil volume: darker or taller means more oil.

What to look for:

  • Shape across the lane: is there a sharp hump in the middle (a crown) or a fairly even spread (flat)? A crown means more help back to the pocket.
  • Where the outside oil stops: on many patterns the outside boards get oil for a shorter distance than the center. That creates drier areas earlier on the outside.
  • How the pattern tapers at the end: an abrupt end gives a sharper move at the breakpoint. A gradual taper gives a smoother arc.

Many sheets also include a composite or tape graph, a cross-section showing measured oil on each board at a few set distances, such as near the arrows, midlane and near the end of the pattern. It’s the best way to see the shape at each stage of the lane.

Forward oil, reverse oil and the load table

Lane machines apply oil on the way down the lane (forward) and often again on the way back (reverse). The sheet usually lists both:

  • Forward oil mostly creates the pattern’s length and the oil further down the lane.
  • Reverse oil adds oil to the front part of the lane on the return trip. It often affects how the front of the pattern holds up as play goes on.

The load table shows the machine instructions: which boards got oil, over what distances, and in how many passes. You don’t have to decode every line. It’s mainly useful when comparing two patterns closely.

The Rule of 31: finding a breakpoint

A common rule of thumb for a starting point is the Rule of 31:

Pattern length − 31 = the board where your ball should be at the breakpoint (where it starts to hook toward the pocket).

Examples:

  • 42-foot pattern: 42 − 31 = 11 board
  • 38-foot pattern: 38 − 31 = 7 board
  • 45-foot pattern: 45 − 31 = 14 board

It’s only a rough guide. Your speed, rev rate and equipment shift the ideal breakpoint, and a pattern’s shape matters as well as its length. Use it to pick a sensible starting line, then adjust to what you actually see.

Turning the sheet into a game plan

Once you’ve read the sheet, ask yourself:

  1. Where does the Rule of 31 put my breakpoint? Set your target and starting position from there.
  2. Is the pattern flat or crowned? A flat pattern rewards accuracy; play the part of the lane you can repeat best. A crowned pattern gives you more room.
  3. How much oil is there? Heavier volume calls for a stronger ball, lighter volume for a weaker or shinier one.
  4. How will it change? Short, light patterns and flat sport patterns can break down fast. See carrydown and lane transition.

Checking it against the lane

A pattern sheet tells you what was applied, not exactly how it plays. Lane surface, oil type, temperature and how many people have bowled since the lanes were oiled all make a difference. Use practice to confirm:

  • Throw a shot toward the outside (around the 5 to 8 board) and see how early it hooks.
  • Throw one farther in (around the 12 to 15 board) and see whether it holds or skids too long.
  • Note where the ball actually starts to turn, and compare it with your Rule of 31 estimate.

Worked example

Say the sheet shows a 42-foot pattern, 24 mL, 2.5:1 ratio:

  • Length: 42 − 31 = aim for a breakpoint around the 11 board.
  • Ratio: 2.5:1 is a sport-style, fairly flat pattern. There won’t be much miss room, so pick a line you can repeat.
  • Volume: 24 mL is a moderate-to-heavier amount. A medium-strong reactive ball might be a good starting choice.
  • Plan: start with your feet and target set to send the ball out to about 11 at the breakpoint, then adjust after a few frames as the lane changes.

For examples of named tournament patterns, see PBA oil patterns explained.

The complete guide to lanes and machines

How a Bowling Alley Works: Lanes, Pins, Pinsetters and More
Read the guide

Keep exploring

Guides from other topics

All topics →